COMBINATION TESTERS When test lab space is an issue. Glove/Sleeve/Blanket Combination Tester Units with 2, 4, or 6 glove/sleeve test positions are available. Units are equipped with 1 to 4 blanket drawers depending on combination style. Select 36” or 46” blanket drawers based on the largest blanket used by your company. Line Hose/Hood/Stick Tester Low profile style Available in 14 or 21 foot maximum stick lengths. Available with a power control panel or can be slaved to another Hanco unit. Capacity of 2 sticks or 4-6 hose or hoods. Sticks can be tested wet or dry (as required by current standards) Can be tested at 37.5KVAC every 6" or 75KVAC every foot (as required by current standards) Standard Features: Any combination can be made using our high voltage testers Automatic: water fill, digital fault detection, digital load sensing, digital leakage readout and power cycle Standard 50KVAC power supply with optional 100KVDC power supply or a combination for both AC and DC testing The high voltage test compartment contains mechanical grounding devices and safety interlock system with audible and visual warning signals covering all entries into the test cabinet for full operator safety and protection. Microprocessor-controlled PLC is self-diagnostic All cabinets are made with formed 12-gauge steel, coated with primer and two coats of epoxy paint. Cabinets are rust and corrosion resistant Automatic ozone depletion and dispersal system with programmed delays to insure complete removal of ozone from the testing cabinet Digital voltmeter indicator Leakage indicators with a single set point for all test positions Leakage digital microamp monitor during the entire duration of the test Voltmeters programmed to save peak voltage Digital cycle timer Insufficient air pressure warning indication Control system has option for either manual or automatic cycle operation Standard input voltage is 240V single phase with other inputs optional (specify when ordering) Standard A.B. Panelview control system with full color display Hanco also offers: CAD-designed lab layouts with all equipment needed for a turnkey lab operation Technical phone support Complete field service support On-site operator training and certification On-site equipment calibration, inspection and certification (as required by ASTM and OSHA). All systems are checked as required for full compliance. Request a quote today! Email

All of our cabinets are locally

manufactured by our partners

at Tri-Fab, Inc.

In compliance with:

 and IEC, IEEE and

OSHA 1910 Standards

 Authorized Hanco Distributors:



HANCO INTERNATIONAL A Division of the Hannon Company 1605 Waynesburg Drive S.E. Canton, Ohio 44707 Phone: (330) 456-4728 Fax: (330) 456-3323 Email:

© 2016 The Hannon Company. All Rights Reserved.

Site Last Updated: 08/20/2020